What should I pay attention to after the battery is discharged? ? How much do you know about this problem? ? Today, the editor of Zhengzhou Kanglida Electronic Power Co., Ltd. will give you some information on this issue. I hope it will be helpful to you. In the future, you can avoid detours when using and purchasing.

　　Self-discharge is small: the grid is made of special lead-calcium alloy to control self-discharge. Long life (design life 7~10 years) and good economy: Yuasa battery grid uses special lead-calcium alloy with good corrosion resistance, together with special separators to keep the electrolyte, and together with the active material of the positive plate, Prevent falling off, so it is a long-life, economical Yuasa battery. Small internal resistance: Because of the small internal resistance, high current discharge characteristics are good.

　　 The gas generated inside the battery during charging is basically absorbed and reduced to electrolyte, and there is basically no reduction in electrolyte. The high liquid-holding electrolyte is absorbed in a special separator and stays in an inactive state, so it can be used even if it falls down. (It can't be used when it falls over 90 degrees). Superior performance: It can release too much gas due to overcharge operation error, preventing the rupture of Yuasa battery.

Excellent recovery ability after deep discharge: In case of long-term discharge, as long as it is fully charged, there is basically no reduction in capacity, and it will soon be able to recover. After the discharge of the battery is completed. Note: We use the time when the battery is used. Failure to charge the battery in time after powering up caused the YUASA battery to show a loss of power. The next time it is used from the beginning, the battery cannot be charged and recharged normally. Therefore, our engineer's advice to everyone is that the Yuasa battery should be charged immediately after discharge.

When not in use, disconnect the connected Yuasa battery, otherwise the connected battery will be over-discharged and damaged within a few days to a week. If the battery is not recharged for a long time after discharge, the board will be oxidized. In other words, a large amount of crystals or solidified lead sulfate is left on the metal plate of the battery. The commonly used charging method will be difficult or impossible to decompose the lead sulfate from the beginning, which will cause premature damage to the battery.

　　 Zhengzhou Kanglida Electronic Power Supply Co., Ltd. was established in 2000, specializing in the development, production and sales of 4 series of 2V, 4V, 6V, 12V maintenance-free lead-acid batteries and electronic chargers. Products are widely used in anti-theft alarm systems, fire alarm systems, building intercom systems, elevator emergency evacuation systems, emergency lights, attendance machines, sprayers, electronic scales, children's electric motorcycles, cartoon inflatable models, car washers, table turntables, parking locks, Strobe lights, traffic lights, DC screens, solar energy, wind energy, UPS, EPS and other backup power systems, if you choose a company, you must choose a company with guaranteed reputation and quality. This company has been operating for many years and has many years of experience. Experienced company, so if you have a need for this, you may wish to contact us, I believe it is a good choice.